Home Up

Photo Album
 

 

 

 

 

This is a USC with our M3 lower and stock kit installed.

Pictured from the right side.

This is a USC with our M3 lower and folding stock kit installed.

Pictured from the left side

This is a custom Hk 94 clone stretch pistol built on a sw cast receiver and sw parts kit. Here the the left side is pictured.

This is a USC w/ our factory Hk lower and folding stock kit installed.

Pictured from the right side.

This is a USC with our M3 w/ folding stock kit installed.

Pictured from the right side.

Here is the Hk clone stretch pistol from the right side.

This is the USC done up as the UMP short barrel with the UMP end cap installed.

note: (This is an NFA item, special paper work MUST be filed)

This is a USC with our UMP Factory conversion (using the UMP Factory mags) and one of our custom compression fit fake suppressors.

This a USC with a factory lower and the A1 end cap and the rear stock changed out.

This is a USC with a factory conversion.

THIS IS A SL8 THAT WE ADDED A G36C PARTS KIT TO.

This is a USC that has had a UMP factory convertion installed with 40 cal and 45 cal 8" and 16" barrels.

This a SP10 with a compression fit fake suppessor and lower rail and vertical grip installed.

This is a SP10 that Top Notch has installed a lower rail and vertical grip. A compression fit full length fake suppressor. Also with a flashlight.

This is a SP10 with a compression fit fake suppressor that also will go onto the Hk94 16" barrel. A lower rail and vertical grip has been installed.

This is a custom end cap for the USC. note: (this can only be used on a USC that has been registered with the ATF as an AOW or SBR. form is supplied

These are the production trigger and sear made in the USA by Top Notch.

They come with a lifetime warrenty.

This is a USA made G3 rear stock with end cap.

This is a Top Notch compression fit fake suppressor.

This is a USA wide forearm grip with bipod attachment.

These are Top Notch 9mm 40cal and 45cal UMP barrels.

These are Top Notch 16" 9mm and 40cal USC barrels. They have the same conture as the 45cal barrel.

This a rear threaded eyelet for attaching your sling to your receiver so that it is not attached to the folding stock.

This is a USC M3 lower that converts your USC to use M3 Grease Gun Mags. This unit uses the factory thumb hole stock.

This is an example of a Top Notch piciatany side rail.

THIS IS A Hk 94 TELE STOCK THAT WE REFINISHED.

THIS IS A Hk 94 WITH THE REFINISHED Hk TELE STOCK.

THIS IS A CLOSE UP OF THE Hk 94 TELE STOCK ON A Hk 94 EXTENDED.

 

This site was last updated 05/22/16

 

Think Outside the box

Stop, look and listen to what is.....  reported!

Last modified: 05/22/16